RoHS Annex IV exemption 32: Lead in solders on printed circuit boards of detectors and data acquisition units for Positron Emission...
Annex IV 32 covers: Lead in solders on printed circuit boards of detectors and data acquisition units for Positron Emission... The annex states an expiry date of 31 December 2019, now past. Article 5(5): an exemption stays valid until a decision on a renewal application.
- Annex
- Annex IV: Applications exempted from the restriction in Article 4(1) specific to medical devices and monitoring and control instruments
- Entry
- 32
- Section of the annex
- Others
- Expiry in the annex
- Expiry date stated in the annex: 31 December 2019 (before 5 November 2026; see the renewal note below)
- Version
- Consolidated version of 1 July 2026
- Official source
- Directive 2011/65/EU (RoHS), consolidated text
Entry (official wording)
Lead in solders on printed circuit boards of detectors and data acquisition units for Positron Emission Tomographs which are integrated into Magnetic Resonance Imaging equipment. Expires on 31 December 2019.
Date wording in the entry
Expires on 31 December 2019.
Validity and renewal
Article 5(5) of the directive: "An application for renewal of an exemption shall be made no later than 18 months before the exemption expires. The existing exemption shall remain valid until a decision on the renewal application is taken by the Commission." This site does not show whether a renewal application for this entry is pending or decided.
Article 5 of the directive sets validity periods and the renewal procedure for exemptions in Annexes III and IV. Its wording is quoted on the Sources and method page. This page repeats only what the annex says about this entry.
Neighbouring entries in Annex IV
- Annex IV 29: Lead in alloys, as a superconductor or thermal conductor, used in...
- Annex IV 30: Hexavalent chromium in alkali dispensers used to create photocathodes in...
- Annex IV 31a: Lead, cadmium, hexavalent chromium, and polybrominated diphenyl ethers...
- Annex IV 33: Lead in solders on populated printed circuit boards used in Directive...
- Annex IV 34: Lead as an activator in the fluorescent powder of discharge lamps when used...
- Annex IV 35: Mercury in cold cathode fluorescent lamps for back-lighting liquid crystal...
Want the exemptions by expiry date?
If we publish the exemptions sorted by the expiry date the annex states, we write to you once. We use the email for nothing else.