RoHS Annex IV exemption 24: Lead enabling vacuum tight connections between aluminium and steel in X-ray image intensifiers
Annex IV 24 covers: Lead enabling vacuum tight connections between aluminium and steel in X-ray image intensifiers. The annex states an expiry date of 31 December 2019, now past. Article 5(5): an exemption stays valid until a decision on a renewal application.
- Annex
- Annex IV: Applications exempted from the restriction in Article 4(1) specific to medical devices and monitoring and control instruments
- Entry
- 24
- Section of the annex
- Others
- Expiry in the annex
- Expiry date stated in the annex: 31 December 2019 (before 5 November 2026; see the renewal note below)
- Version
- Consolidated version of 1 July 2026
- Official source
- Directive 2011/65/EU (RoHS), consolidated text
Entry (official wording)
Lead enabling vacuum tight connections between aluminium and steel in X-ray image intensifiers. Expires on 31 December 2019.
Date wording in the entry
Expires on 31 December 2019.
Validity and renewal
Article 5(5) of the directive: "An application for renewal of an exemption shall be made no later than 18 months before the exemption expires. The existing exemption shall remain valid until a decision on the renewal application is taken by the Commission." This site does not show whether a renewal application for this entry is pending or decided.
Article 5 of the directive sets validity periods and the renewal procedure for exemptions in Annexes III and IV. Its wording is quoted on the Sources and method page. This page repeats only what the annex says about this entry.
Neighbouring entries in Annex IV
- Annex IV 21: Cadmium in phosphor coatings in image intensifiers for X-ray images until 31...
- Annex IV 22: Lead acetate marker for use in stereotactic head frames for use with CT and...
- Annex IV 23: Lead as an alloying element for bearings and wear surfaces in medical...
- Annex IV 25: Lead in the surface coatings of pin connector systems requiring nonmagnetic...
- Annex IV 26: Lead in the following applications that are used durably at a temperature...
- Annex IV 27: Lead in - solders, - termination coatings of electrical and electronic...
Want the exemptions by expiry date?
If we publish the exemptions sorted by the expiry date the annex states, we write to you once. We use the email for nothing else.